Why does the fabric shrink?
Jun 15, 2022
Leave a message
1. The effect of fiber and shrinkage
After the fiber itself absorbs water, it will swell to a certain extent. Usually the swelling of fibers is anisotropic (except for nylon), that is, the length is shortened and the diameter is increased. Usually, the percentage of the difference between the length of the fabric before and after it is launched and its original length is called the shrinkage rate. The stronger the water absorption capacity, the more severe the swelling, the higher the shrinkage rate, and the worse the dimensional stability of the fabric.
The length of the fabric itself is different from the length of the yarn (silk) thread used, and the difference between the two is usually expressed by the shrinkage rate.
Weaving shrinkage (%) = [yarn (silk) line length - fabric length] / fabric length
After the fabric is in the water, the length of the fabric is further shortened due to the swelling of the fiber itself, resulting in a shrinkage rate. The shrinkage rate of the fabric is different, and the size of the shrinkage rate is different. The tissue structure and weaving tension of the fabric itself are different, and the shrinkage rate is different. When the weaving tension is small, the fabric is compact and thick, and the weaving shrinkage rate is large, and the shrinkage rate of the fabric is small; the weaving tension is large, the fabric is loose and thin, the weaving shrinkage rate is small, and the shrinkage rate of the fabric is large. In the dyeing and finishing process, in order to reduce the shrinkage rate of the fabric, pre-shrinking is often used to increase the weft density and increase the shrinkage rate in advance, thereby reducing the shrinkage rate of the fabric.
2. Reasons for shrinkage:
(1) When the fiber is spinning, or when the yarn is weaving and dyeing, the yarn fiber in the fabric is stretched or deformed by external force, and the yarn fiber and fabric structure generate internal stress, which is in a static dry relaxation state. , or in the static wet relaxation state, or in the dynamic wet relaxation state or the full relaxation state, the release of internal stress of different degrees makes the yarn fibers and fabrics return to the initial state.
(2) Different fibers and their fabrics have different degrees of shrinkage, mainly depending on the characteristics of their fibers-hydrophilic fibers have a larger degree of shrinkage, such as cotton, hemp, viscose and other fibers; Less shrinkage, such as synthetic fibers, etc.
(3) When the fiber is in the wet state, it will expand due to the action of the immersion liquid, which will increase the diameter of the fiber. For example, on the fabric, the radius of curvature of the fiber at the interwoven point of the fabric is forced to increase, resulting in a shortening of the length of the fabric. For example, cotton fibers expand under the action of water, the cross-sectional area increases by 40~50%, and the length increases by 1~2%, while synthetic fibers shrink by heat, such as boiling water shrinkage, generally about 5%.
(4) When the textile fiber is heated, the shape and size of the fiber change and shrink, and it cannot return to the original state after cooling, which is called thermal shrinkage of the fiber. The percentage of length before and after heat shrinkage is called the heat shrinkage rate, which is generally measured by boiling water shrinkage. In boiling water at 100 °C, the percentage of fiber length shrinkage is expressed; hot air is also used. The percentage of shrinkage is measured in the steam method, and the percentage of shrinkage is measured in the steam exceeding 100 ℃. Fibers behave differently due to different conditions such as internal structure, heating temperature and time. For example, the boiling water shrinkage rate of processed polyester staple fiber is 1%, the boiling water shrinkage rate of vinylon is 5%, and the hot air shrinkage rate of vinylon is 50%. Fibers are closely related to the dimensional stability of textile processing and fabrics, which provide some basis for the design of subsequent processes.

